Stainless Steel Skirting Installation Guide

Installing stainless steel skirting is easier than you think! Our snap-on system eliminates the need for backing boards and complex adhesives. This comprehensive guide will walk you through every step of the installation process.

Tools and Materials Needed

Item	Quantity	Purpose
Stainless steel skirting profiles	As needed	Main material
Measuring tape	1	Accurate measurements
Cuticle or miter saw	1	Cutting profiles to size
Corner brackets	Per corner	External corner joints
Construction adhesive	1 tube	Optional backup adhesion
Clean cloth	Multiple	Cleaning surfaces
Level	1	Ensuring straight installation

Preparation Steps

Step 1: Measure Your Space

• Measure the length of each wall where skirting will be installed
• Note any corners, doorways, or obstacles
• Add 5-10% extra for cuts and waste
• Record measurements in both metric and imperial units

Step 2: Prepare the Surface

• Clean the wall base thoroughly - remove dust, dirt, and old adhesive
• Ensure the surface is dry and level
• Fill any gaps or imperfections in the wall
• Prime porous surfaces if necessary

Installation Process

Step 3: Cut Profiles to Length

Using a fine-toothed saw or angle grinder with cutting disc:

• Mark cutting lines clearly with tape
• Cut at 45° angles for corner joints
• Smooth cut edges with fine sandpaper
• Test fit each piece before final installation

Step 4: Install Corner Brackets

For external corners:

• Position bracket at corner point
• Mark drilling points
• Drill pilot holes (use wall plugs for plasterboard)
• Secure bracket with screws

Step 5: Snap-On Installation

Our signature snap-on system:

1. Start from one end of the wall
2. Align the back clip with the wall surface
3. Press firmly until you hear a click
4. Continue along the wall, overlapping joints
5. Use corner brackets for external corners
6. Check alignment frequently with a level

Finishing Touches

Step 6: Clean and Inspect

• Remove any adhesive residue immediately
• Wipe surfaces with a clean, damp cloth
• Inspect all joints and corners
• Touch up any scratches with matching polish

Maintenance Tips

• Daily: Dust with soft cloth
• Weekly: Clean with mild detergent and water
• Monthly: Inspect for loose sections
• Annually: Check seal integrity in wet areas

Common Mistakes to Avoid

1. Skipping surface preparation
2. Not accounting for expansion gaps
3. Using wrong adhesive type
4. Installing on uneven surfaces without leveling
5. Rushing the snap-on process